Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
- Engines
+ Mechanical part of the G16 engine
+ Mechanical part of the J20 engine
- Cooling of the engine
+ General description
+ Diagnostics
- Maintenance
Check of level of cooling liquid
Service and repair of the cooling system
Washing and filling of the cooling system
Regulation and check of a tension of a belt of the cooling fan
+ Routine maintenance of the vehicle
Necessary service materials
Technical characteristics of the rotating inhaling moment
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Washing and filling of the cooling system
|
|
Uncover a radiator when the engine cools down. Slowly turn a cover on the left until it does not reach the point "feet" (You do not press when you turn). Wait pressure so far it will be dumped (the hissing sound indicates it), then press a cover and continue to turn on the left.
|
|
In order to avoid a burn do not uncover a radiator, the engine and a radiator still hot so far. The burning liquid and steam can be splashed out under pressure if it is uncovered too early. |
Having uncovered a radiator, start the engine, the top hose of a radiator will not heat up yet (it shows that the thermostat is open and cooling liquid moves on system).
Switch off the engine and open a drain stopper of a radiator to merge cooling liquid.
|
|
Close a drain stopper (1). Add water until the system is filled, and start the engine until again the top hose of a radiator heats up.
|
Repeat points 3) and 4) several times until the merged liquid does not become almost colourless.
Merge the cooling system, and then strong close a drain stopper of a radiator.
Disconnect a hose from the tank (1). Remove the tank and merge liquid. Rub and clean the tank with soap and water inside. Well wash out it clear water and drain. Install the tank and a hose into place.
Add mix 50/50 ethylene of the glycoleft antifreeze of high quality and water to a radiator and the tank. Fill a radiator to a bulk mouth and the tank to a mark of the FULL level (2). Establish a tank cover, having leveled arrows (4) on the tank and a cover.
|
|
1 — a hose from the tank
2 — a mark of high level
3 — a mark of low level |
Start the engine with an open cover of a radiator until the top hose of a radiator does not heat up.
At the engine idling fill in cooling liquid in a radiator to the level of a jellied mouth. Establish a radiator cover, having convinced that clips of a cover are leveled with a tank hose.
|
|
|
|
