Suzuki Grand Vitara
+ General information
- Maintenance and lubricant
+ Service
- Maintenance
- Engine
Driving belt
GRM belt (only for G16 engines)
Valvate gap (only for G16 engines)
Engine oil and filter
Cooling liquid
Exhaust system
+ System of ignition
+ Fuel system
+ System of decrease in toxicity of an exhaust
+ Chassis and body
Final survey
The recommended liquids and lubricants
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Cooling liquid
|
|
In order to avoid receiving burns, do not turn off a radiator cover until the radiator cooled down. Hot liquid and steam can take off under pressure if the cover is turned off too early. |
|
|
|
|
Turn off a radiator cover on the cooled-down engine.
|
Turn off a drain stopper of a radiator and merge cooling liquid.
Remove a broad tank, sideways from a radiator and merge liquid.
Reliably tighten a stopper. Also install a broad tank.
Fill in necessary amount of antifreeze in a radiator and start the engine for 2 – 3 minutes on single turns. It will distil the air which remained in the cooling system. Kill the engine. Add necessary amount of antifreeze so far level will not reach a radiator mouth. Twirl a radiator cover.
Add antifreeze in a broad tank to the mark "FULL". Then twirl a tank stopper before coincidence of tags on a tank and a cover.
|
|
At installation of a cover of a broad tank, level tags on a tank and a cover. |
When replacing cooling liquid, use mix from an equal amount of water and antifreeze for the countries where ambient temperature during the winter period is below 16 °C (3 °F), and mix from 70% of water and 30% of antifreeze for the countries where ambient temperature does not fall below -16 °C (3 °F). For the countries in which there are no negative temperatures anyway use mix of 70% of water and 30% of antifreeze for prevention of corrosion, for protection and lubricant.
|
|
1 — a broad tank
2 — a mark at most
3 — a mark at least
4 — a tag
5 — a cover of a broad tank |
|
|
|
|
