Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
- Suspension bracket
+ Forward suspension bracket
- Back suspension bracket
General description
+ Diagnostics
- Service out of a workshop
Shock-absorber
Cylindrical spring
Lower draft
Top draft
Side draft
Zadny Bridge and bearing of a wheel
Internal oil epiploon of the back bridge
Case of the back bridge
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Cylindrical spring
Removal
|
|
Lift the car and remove a back wheel.
|
|
Floor jack (2) prop up the case of the back bridge (1).
|
|
|
Disconnect an eye of a cable of a parking brake (1) from a frame the chassis and the plug (3) from a cross-piece (2).
|
|
|
Remove the lower fixing bolt (1) of the shock-absorber.
|
|
|
Remove plugs of the sensor of speed of a wheel (1) from the top draft (2) and the bridge case if there is a system of anti-blocking of brakes of ABS.
|
|
|
For the right side – remove an E-shaped ring of fixing of a brake tube from a cross-piece and disconnect a hose of a sapun from the bridge case.
|
Gradually lower the case of the back bridge until then when it is possible to remove a cylindrical spring.
Remove a cylindrical spring.
|
|
Installation
|
|
|
|
Establish a cylindrical spring (3) in a nest of a spring (2) on the case of the bridge (1), and then lift the bridge case.
|
|
|
At installation of a cylindrical spring combine the end of a spring with a step part (4) nests of a spring of the back bridge. |
Establish the lower bolt of the shock-absorber. Do not tighten a nut.
|
|
1 — the center of a body
2 — outer side of a body |
Install the wheel speed sensor plug (if is available) and an E-shaped ring and attach a hose of a sapun to the bridge case.
|
|
Attach an eye of a cable (1) to a frame the chassis (4) and the plug (3) to a cross-piece (2). Remove a jack from under the bridge case.
|
|
|
Establish a wheel and tighten wheel nuts to the specified value of the moment of an inhaling. Inhaling moment: nut of a wheel (a): 100 N • m (10.0 kg-m, 72.5 pounds feet).
|
Lower the elevator and tighten the lower nut of the shock-absorber to the specified value of the moment of an inhaling. Inhaling moment: Lower nut of the shock-absorber: (b) — 100 N • m (10.0 kg-m, 72.5 pounds feet).
For tightening of the lower nut see in this Chapter the Note in the Section Shock-absorber (Installation).
|
|
1 — the center of a body
2 — outer side of a body |
|
|
|
|
