Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 release

Repair and operation of the car


Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
- Forward and back differentials
   - Forward diffrentsiat
      + General description
      + Diagnostics
      - Service out of a workshop
         + Servicing
         - Check
            Control system of the four-wheel drive
            Drive
            Air pump
         + Removal and installation
         Removal
         Installation
   + Back differential
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment

9df16362

Air pump

Removal/installation

 PERFORMANCE ORDER

    Disconnect air hoses and a fitting from the air pump. Having removed bolts, remove the pump
    For installation perform the procedure of removal upside-down. Inhaling moment: 13 N • m (1.3 kg-m, 9.5 pounds feet).

Check

 PERFORMANCE ORDER

    Install the special tool, the voltmeter and the battery on the pump.
1 — the pump
    Tighten an adjusting bolt of the special tool against the stop and close its side opening for check of air by means of a fuel hose as a deaf stopper. Special tool (A): 09918-18110. Check that the motor began to work (its sound was heard) when the battery is connected, and stopped when the specified pressure is reached. Check whether there is no air leak. The specified pressure: 30.0 – 45.0 kPa (0.30 – 0.45 kg/cm2, 4.25 – 6.40 pounds on sq. inch). Check that indications of the voltmeter were within the values given below:
      When the motor works: 0 – 1 Volt When the motor ceased to work: 10 – 14 Volts

Do not allow the motor to work continuously more than 10 seconds that it did not break.