Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
- Transfer
General description
+ Diagnostics
- Service out of a workshop
Oil of the transfer case
Gear shifting lever
Switch of transfer of the all-wheel drive car
+ Oil epiploons of transfer
Speed sensor
Back fixture of the engine
Transfer module
Removal
Installation
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Gear shifting lever
Removal
|
|
|
|
Uncover (1) the central console boxes.
|
Remove the top cover (2) of a back central console box.
Remove 6 bolts, and then a back central console box.
Uncover a casing.
|
|
Lift a casing No. 3, a casing No. 2 (1).
|
Remove a casing clip, and then lift a casing No. 1 (2) from the case of the lever of switching of the transmission (3).
Fingers press a cover of the case of gear shifting (4) down, turn it counterclockwise and pull out the lever of gear shifting (5).
|
|
Check
|
|
Check the lower part of the lever of gear shifting and an adjusting leaf of the lever for excessive wear.
Check a casing for damages.
If necessary, replace or correct.
|
|
If adjusting bolts (1) of the lever of switching are replaced or drawn, tighten them to the specified value of the moment of an inhaling.
|
When replacing adjusting bolts (1) of the lever of switching the carving clamp for blocking of a carving will be required. "B": clamp of a carving 99000-32110. Moment of an inhaling (a): 17 N • m (1.7 kg-m, 12.5 pounds feet).
Apply lubricant on the rotating parts and a nest, then install the gear shifting lever. "A": lubricant 99000-25010.
|
|
Install the lever of gear shifting (2) in the lever case.
|
Having pressed a hand a cover of the case of the lever of gear shifting (1) down, turn it (1) clockwise.
|
|
Establish a casing No. 1 (1) from within salon and reliably fix it by a new clip (2).
|
|
|
Establish a casing No. 2 (2) with a cover of a casing (3) and an arm of a console box (1).
|
Install a console box.
|
|
Make sure that the extending end of a casing No. 3 was combined with a console box. |
|
|
Having combined a casing No. 3 (1) with covers (2), establish covers (2) on the central console boxes. (a): 17 N • m (1.7 kg-m, 12.5 pounds feet).
|
|
|
|
|
