Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
- Electric equipment
- Body electric equipment
+ Main description of the control unit of body electronics
- Codes of diagnostics of malfunctions
Check of a diagnostic code of malfunctions (KDN)
Cleaning of a diagnostic code of malfunction (KDN)
Table of a diagnostic code of malfunction (KDN)
Information of the scanner
The terms and formulations used in the scanner
The table of signals at the exit of the SUZUKI scanner in the test mode
+ General description
+ System of lighting
+ System of electric equipment
+ Tools/information for drivers
|
Codes of diagnostics of malfunctions
Check of a diagnostic code of malfunctions (KDN)
With use of the SUZUKI scanner
|
|
To prepare the SUZUKI scanner.
|
|
At the switched-off ignition to attach the device to the socket of the data transmission channel (DTC) (1) which is under the dashboard from the driver's chair. Additional device(s): SUZUKI scanner.
|
Include ignition.
Read the diagnostic code of malfunction represented on the display of the SUZUKI scanner and unpack it or write down.
For additional information see the Reference book of the mechanic.
If process of information transfer between the control unit of body electronics and the SUZUKI scanner is impossible, check whether this process with the control unit on other car is carried out.
If information transfer process in this case is carried out, the SUZUKI scanner is in good repair. Then check the socket of a data transmission channel and the consecutive chain which is in the car with which process of information transfer did not manage to be carried out.
After completion of check, switch off ignition and disconnect the SUZUKI scanner from the socket of a data transmission channel.
|
|
Without use of the SUZUKI scanner
|
|
|
|
Check that with inclusion of ignition also the Hours/speed display turned on.
|
Using a repair wire (2), ground contact of the diagnostic switchboard in the place of control connection (3).
At the included ignition and the idle engine, read KDN represented on the Hours/speed display. Find compliance in the Table of a diagnostic code of malfunction (KDN).
After check is finished, switch off ignition and disconnect a repair wire from the place of control connection.
|
|
2 — a repair wire
3 — control connection
4 — "mass" of the case
5 — an air inlet fragment |
|
|
|
|
