Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 release

Repair and operation of the car


Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
- Windows, mirrors, locks and security measures. Immobilizer
   - Windows, mirrors, locks and security measures
      + General description
      + Diagnostics
      - Maintenance
         + Cleaner and washer of a windshield
         Screen wiper electric motor
         Windscreen washer pump
         Control system of electrowindow regulators
         System of blocking of locks (if the system allowing to get to interior of the car without key is not installed)
         + System of blocking of doors with a radiobrelka (if the system allowing to get to interior of the car without key is installed)
         System of the electric drive of mirrors
         Heater of side mirrors (if it is equipped)
         Heater of a front seat (if it is equipped)
   + Immobilizer
+ Electric equipment

9df16362

Screen wiper electric motor

 PERFORMANCE ORDER

    As shown in the drawing below, use the battery of 12 V to connect a positive conclusion to the plug "A" and a negative conclusion to a black wire (2) (for type "A") or to the plug "E" (for type "B").

A — type A
B — type B

    If the motor (1) works at low turns (45 – 55 min.-1), then this normal state. For check of work on high turns, connect a positive conclusion of the battery to the plug "B" and a negative conclusion to a black wire (2) (for type "A") or to the plug "E" (for type "B"). If the motor works at high turns (67 – 83 min.-1), then this normal state. Check of automatic switching off.
      Connect a positive conclusion of 12 V of the battery to the plug "A" of the motor of a screen wiper (1) and a negative conclusion to a black wire (2) (for type "A") or to the plug "E" (for type "B") and include a screen wiper. Disconnect the plug "A" from the battery and switch off a screen wiper. Connect among themselves plugs "A" and "D" by means of a connecting wire (3) and connect the plug "C" to a positive conclusion of the battery. Pay attention that the motor of a screen wiper works once and stops in final situation. Repeat procedures a – c several times and check that the motor always stops in this situation.

A — type A

B — type B