Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 release

Repair and operation of the car



Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
- Steering
   + Suspension bracket, wheels and tires
   + Adjustment of angles of installation of wheels of a forward suspension bracket
   + System of the power steering
   - Steering wheel and steering column
      + The steering wheel and a steering column which is not equipped with a safety cushion
      - A steering wheel and a steering column with a safety cushion
         General description
         + Diagnostics
         - Service out of a workshop
            + Precautionary measures at service
            The module (having inflated) the driver's pillows
            + Steering wheel
            Contact coil and understeering switches
            Steering column (at not a cabriolet)
            The top shaft of steering (at not a cabriolet)
            Steering column (at a cabriolet)
            Steering lock (ignition switch)
            Lower shaft of steering
            Check of a steering column and top shaft of steering on existence of accident damages (at not a cabriolet)
            Check of a steering column on accident damages (at a cabriolet)
            Lever of an adjustable unblocking of a steering column
         Specifications of the moment of an inhaling
         Special tool
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment


9df16362

Steering column (at not a cabriolet)

When the steering column is removed from the car, it is very easy to damage it.

If to drop it vertically, the steering shaft can break or plastic pins which regulate column length can weaken; if to lean on it, it can be bent or deformed. Any of the listed damages can worsen udaropogloshchayushchy properties of a column.

Weakening fixing bolts and nuts of a steering column, be convinced that the steering column and the top steering shaft are disconnected. If before weakening of fixing bolts and nuts not to separate a steering column and the top steering shaft, it can damage the top coupling and a fixing bracket of the top steering shaft.


When carrying out service of a steering column or any knots established on it it is necessary to remove a steering wheel. But if the steering column is removed only to provide access to toolbar components, the steering wheel can be not removed from a column.

Removal

Never put a column vertically on the steering wheel turned down by the module (naduv) of a safety cushion. It can lead to a trauma.


Never turn a steering wheel when the steering column and a steering wheel are removed. The turn of a steering wheel more, than on two and a half turns, will break the contact coil.


 PERFORMANCE ORDER

    Disconnect "minus" (–) a battery cable. Disconnect system of a safety cushion. See preventions at the beginning of this Chapter. Remove a steering wheel and the contact coil with understeering switches if it is required. See in this Chapter Sections the Steering wheel and the Contact coil and understeering switches. If the steering wheel and/or understeering switches remain on the place, execute the following manipulations:
      Turn a steering wheel so that forward wheels of the car looked directly forward. Turn the ignition switch in the provision of "LOCK" and take out a key.
    Uncover a steering column (1).
    Disconnect all cables of the following knots:
      Contact coil and understeering switches. Ignition switch.
    Remove a bolt (1) and a nut (2) of the top coupling of the top steering shaft.
    Remove fixing bolts (2 pieces) (2) and nuts (2 pieces) (3) steering columns (1).
    If there is a cable of blocking of the switch (key) (1), disconnect it from the ignition switch, having turned the ignition switch in the provision of "ACC".
    After a detachment turn the ignition key in the provision of "LOCK". Remove a steering column from the car.

Survey

Check serviceability of a steering column and existence of damages as below in this Chapter in the Section Check of a steering column and top shaft of steering on existence of accident damages is described (at not a cabriolet).

Installation

After tightening of fixing bolts of a steering column it is necessary to tighten bolts of the coupling of a steering shaft.


 PERFORMANCE ORDER

    Make sure that the provision of forward wheels and a steering wheel correspond to the rectilinear movement of the car.
    If there is a cable of blocking of the switch (key) (1), connect it to the ignition switch, having turned the ignition switch in the provision of "ACC". Then turn the ignition switch in the provision of "LOCK".
    Combine a point of "A" of a steering column (1) with an opening for a bolt of "B" of the top coupling of the top steering shaft. Then connect the top coupling of the top steering shaft.
    Establish a steering column (1) by the contact top party of the lower vents to fixing bolts. Tighten the lower fixing nuts (3) steering columns, and then the top fixing bolts (2) to the specified values of the moment of an inhaling. Inhaling moment: fixing bolts and nuts of a steering column (b): 25 N • m (2.5 kg-m, 18.0 pounds feet).
    Establish a bolt (2) of the top coupling of the top steering shaft and a nut (1). Tighten a nut (1) of the top coupling of the top steering shaft till the specified inhaling moment. Inhaling moment: a nut of the top coupling of the top steering shaft — (a): 23 N • m (2.3 kg-m, 17.0 pounds feet).

Do not reuse a bolt and a nut of the top coupling of the top shaft. For installation take new.

    If the contact coil and understeering switches were removed, establish them as it is described in this Chapter in the Section the Contact coil and understeering switches. Connect all cables which were disconnected at removal of a steering column.
    Establish a cover of an opening of a steering column (1).
    If the steering wheel was removed, establish it as the Steering wheel is described in this Chapter in the Section. Connect "minus" (–) a cable to the battery. After installation of a steering column check that the system of a safety cushion is included. See preventions at the beginning of this Chapter.