Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1.1.2. Technical characteristics
      3.1.1.3. Sinhronizatsionnye labels timing
      3.1.1.4. Compression check
      3.1.1.5. A gazoraspredelitelnyj belt
      3.1.1.6. Натяжитель газораспределительного a belt, an asterisk
      3.1.1.7. Additional приводные belts
      3.1.1.8. A camshaft cover
      3.1.1.9. A camshaft epiploon
      3.1.1.10. An epiploon of an intermediate shaft
      3.1.1.11. Epiploons of a cranked shaft
      3.1.1.12. A head of cylinders
      3.1.1.13. Hydraulic pushers
      3.1.1.14. A flywheel
      3.1.1.15. Engine fastenings
      3.1.1.16. The oil pallet
      3.1.1.17. The oil pump and маслозаборный a branch pipe
   + 3.1.2. 5-cylinder engines
   + 3.1.3. 6-cylinder engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

3.1.1.8. A camshaft cover
ENGINE ADR

Removal

PERFORMANCE ORDER

1. Remove the top cover of the engine.

2. Remove an air inlet located between the air filter and a casing of a throttle.

3. Disconnect wires from the ignition coil. Disconnect a grounding wire.

4. Braid nuts and uncover a camshaft.

5. Remove linings and маслоотражатель from a cover

Installation

PERFORMANCE ORDER

1. Clean surfaces of a cover and a head of cylinders, establish new linings.

2. Establish маслоотражатель.

3. Establish a cover on a head and tighten bolts.

4. Establish the remained details.

ALL ENGINES, EXCEPT ADR

Removal

PERFORMANCE ORDER

1. Remove the top cover газораспределительного a belt.

2. Remove the top part of a back cover газораспределительного a belt.

3. Braid nuts of a cover of a camshaft.

4. Remove strengthening plates and uncover a camshaft.

5. Remove маслоотражатель.

6. Remove a lining.

7. Remove the semicircular lining located in a flute of a cover of the forward bearing of a camshaft and get rubber заглушку, located in a back part of a head of cylinders.

Installation

PERFORMANCE ORDER

1. Clean surfaces of a cover and a head of cylinders.

2. Establish details upside-down.