Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 release

Repair and operation of the car


Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
- Transmissions
   - Mechanical transmission (type 1)
      Description of system
      Diagnostics
      - Service out of a workshop
         Oil for the transmission
         Gear shifting lever
         Illumination switch
         Back fixture of the engine
         Removal of the transmission
         Installation of the transmission
         The case extender (for model with the drive on two wheels and the G16 and J20 engine)
         Oil epiploon of the case extender (for model with the drive on two wheels and the G16 and J20 engine)
   + Mechanical transmission (type 2)
   + Automatic transmission (4 A/T)
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment

9df16362

Service out of a workshop

Oil for the transmission

Check and replacement

 PERFORMANCE ORDER

    Before replacement or check of oil be convinced that the engine is switched off, and horizontally lift the car. At the lifted car check the level and leak of oil. If leak is found, eliminate it. Merge old oil and pour the specified quantity (approximately to a-level opening) the new specified oil.
  • It is strongly recommended to use SAE 75W-90 oil.
  • When raising the car for any other, than replacement of oil, service, check leak of oil and a condition of hoses of a sapun.
  • If in the merged oil there is water or a rust, check a hose of a sapun and a casing of the transmission and transfer.
      Specification of oil:
        oil brand: API GL-4 viscosity: SAE 75 W-85, 75 W-90 or 80 W-90 oil capacity: 1.5 liter (3.2/2.6 USA/Imp. pints)
Scheme of viscosity of society of automobile engineers (USA).
    Tighten a drain stopper (1) and a stopper of level / a bulk opening (2), as shown below, previously apply sealant on a carving. "A": sealant 99000-31110. Moment of an inhaling (a): 23 N • m (2.3 kg-m, 17.0 pounds feet).

  • Oil of the transmission cannot be filled in through a part of the lever of gear shifting.
  • Do not weaken and do not remove a bolt of a shaft of an intermediate gear wheel of a backing (3).