Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
- 10. Brake system
   + 10.1.2. Shock-absorbers
   + 10.2. Technical characteristics
   10.3. Prorolling of hydraulic system
   10.4. Hydraulic tubes and hoses
   10.5. Brake overlays of forward brakes
   10.6. Brake overlays of back wheels
   10.7. Brake Pads back brakes
   10.8. A brake disk of a forward wheel
   10.9. A brake disk of a back wheel
   10.10. A brake drum of a back brake
   10.11. A support of a forward brake
   10.12. A support of a back brake
   10.13. The wheel cylinder of a back brake
   10.14. The main brake cylinder
   10.15. A brake pedal
   10.16. The vaakuumnyj amplifier
   10.17. The vacuum valve of a servoamplifier
   10.18. A rope of a manual brake
   10.19. The lever of a manual brake
   10.20. The valve of adjustment of pressure in a contour of back brakes (till 96 of century)
   10.21. The switch of fires of a stoplight
   10.22. The general description of system of antiblocking of brakes (ABS)
   10.23. System ABS elements
   10.24. The vacuum pump (diesel and petrol engines in volume 2,3)
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

10.18. A rope of a manual brake
Removal

PERFORMANCE ORDER

1. Disconnect a rope from the balance weight and get a braid of a rope from fastening.

2. Remove a braid of a rope from fastenings. Turn off a fixing nut.

3. Disconnect a rope from the lever of a manual brake and remove it from the car.

Installation

Installation is spent upside-down removals.

Adjustment

PERFORMANCE ORDER

1. Turn off an adjusting nut of a rope of a manual brake to weaken a tension of ropes.

MODELS WITH BACK DRUM-TYPE BRAKES

PERFORMANCE ORDER

2. Squeeze out a brake pedal some times.

3. Lift the lever of a manual brake on three clicks.

4. Twirl an adjusting nut so that brake Pads began to concern brake drums. Release a manual brake and check up, that wheels rotated freely.

5. Lift the lever of a manual brake on three clicks and check up correctness of adjustment.

MODELS WITH BACK DISK BRAKES

PERFORMANCE ORDER

2. Check up, that levers of a manual brake on supports of both back wheels concerned an emphasis.

3. Squeeze out a brake pedal some times to establish a correct backlash between brake overlays and a disk.

4. Twirl an adjusting nut of a manual brake so that levers of manual brakes have slightly risen from an emphasis. Turn off an adjusting nut on two complete revolutions back.

5. Check up, that both levers densely concerned an emphasis.

6. Check up adjustment of a manual brake and repeat it if it is necessary.