Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Systems of start, ignition
   - 8.1.1. Introduction
      8.1.2. Technical characteristics
      + 8.1.3. The accumulator
      + 8.1.4. The Generator / system of additional charge of the accumulator
      8.1.5. Replacement of the holder of brushes and a regulator of pressure of the generator
      8.1.6. Check of system of start of the engine
      8.1.7. A starter
      8.1.8. An inlet gas pipeline
      8.1.9. A cable of gas/lever throttle заслонки (DB)
      8.1.10. A cable of management of gas (DB)
      8.1.11. A contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. The fuel thermostat
      8.1.14. The hydrovalve case
      8.1.15. A cable of gas/lever throttle заслонки (ДД)
      8.1.16. A cable of management of gas (ДД)
   + 8.2. Ignition system (petrol engines)
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice



8.1.6. Check of system of start of the engine
THE GENERAL DATA

If the starter does not join at key turn in the ignition lock, it can be caused following reasons:

– The accumulator is faulty;
– Bad electric connections;
– The involving relay is faulty;
– The starter is faulty.











9df16362 9df16362