Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   + 3.1.1.2. Technical characteristics
   - 3.1.2. 5-cylinder engines
      3.1.2.2. Technical characteristics
      3.1.2.3. Sinhronizatsionnye labels timing
      3.1.2.4. Compression check
      3.1.2.5. A gazoraspredelitelnyj belt
      3.1.2.6. Натяжитель газораспределительного a belt, an asterisk
      3.1.2.7. Additional приводной a belt
      3.1.2.8. A camshaft cover
      3.1.2.9. A camshaft epiploon
      3.1.2.10. Epiploons of a cranked shaft
      3.1.2.11. A head of cylinders
      3.1.2.12. Hydraulic pushers
      3.1.2.13. A flywheel
      3.1.2.14. Engine fastenings
      3.1.2.15. The oil pallet
      3.1.2.16. The oil pump and маслозаборный a branch pipe
   + 3.1.3. 6-cylinder engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


9df16362

3.1.2.13. A flywheel

Removal

PERFORMANCE ORDER
1. In models with a mechanical transmission remove a transmission and coupling.
2. In models with an automatic box remove a transmission.
3. Unscrew flywheel bolts, preliminary having stopped it.
4. Remove a flywheel.

Check

PERFORMANCE ORDER
1. Check up a flywheel on presence of deterioration and damages. At detection of those, address to the expert.
2. If you establish a new flywheel, on it there is only a label for piston N1 installation in ВМТ. It will be necessary for you to put on it a label for installation of a corner of an advancing of ignition (and = 36,5 mm).
3. Examine the needle bearing of a cranked shaft.

Installation

Intermediate washer (1) and a lining (2) leading disks of an automatic transmission


PERFORMANCE ORDER
Installation is spent upside-down removals. Measure distance between a back surface of the block of cylinders and the surface of a leading disk joined to the hydrotransformer (21,3–22,9 mm).