Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
- System of start
+ General description
- Diagnostics
Repair of the block
Analysis
Assembly
Survey
Work check
Specifications
Type of 0.9 kV
Necessary materials
Special tool
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Analysis
|
|
- Before analysis of a starter, surely arrange marks in those places (A and B) to avoid possible mistakes.
- Do not clamp a collar a vice and do not beat it with the hammer at repair.
|
|
|
1 — the electromagnetic switch
2 — a forward casing
3 — a collar |
|
|
Remove a protector (if is) and the electromagnetic switch.
|
|
1 — the electromagnetic switch
2 — a protector |
|
|
Do not disassemble this switch. If it is faulty, replace it as assembly. |
|
|
1 — the electromagnetic switch
2 — a spring
3 — the piston |
Remove bolts, then disconnect assembly of a reducer from assembly of a starter.
|
|
1 — bolts
2 — assembly of a reducer |
To repair assembly of a reducer, remove laying and planetary transfers.
|
|
1 — planetary transfer
2 — laying |
Remove rubber consolidation and a plate.
|
|
1 — rubber consolidation
2 — a plate |
Remove assembly of the lever together with the lever.
|
|
1 — assembly of the lever
2 — the lever |
Release the lock ring of a gear fixed by a persistent ring.
|
|
1 — a persistent ring
2 — a lock ring of a gear
3 — assembly of the obgonny coupling |
Remove a persistent ring, then extend a lock ring of a gear, the obgonny coupling and internal transfer. Special tool (A): 09900-06107.
|
|
1 — internal transfer
2 — a persistent ring
3 — a lock ring of a gear
4 — the obgonny coupling |
Remove a back bracket and the brush holder.
|
|
1 — a back bracket
2 — an anchor
3 — a collar |
Remove an anchor from a collar and then a ball since the end of a shaft of an anchor.
|
|
1 — an anchor
2 — a collar
3 — a ball |
Remove the brush holder from a back bracket.
|
|
1 — a back bracket
2 — the brush holder |
|
|
Remove springs of brushes and a brush.
|
Remove a cap of a back bracket, and then remove a back sleeve.
|
|
1 — back sleeves
2 — a cap of a back bracket
3 — a back bracket |
|
|
|
|
