Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 release

Repair and operation of the car



Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
- System of ignition
   - System of ignition for the G16 engine
      + General description
      + Diagnostics
      - Service of the vehicle
         Check of a spark of ignition
         Check of time of an advancing of ignition
         Wire of high voltage
         Assembly of the coil of ignition (igniter and coil of ignition)
         Spark plug
         The resistor an ignition advancing (if it is established)
         CMP sensor
         Noise suppressor
      Specification, torque of an inhaling
      Special tool
   + System of ignition for the J20 engine
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment


9df16362

The resistor an ignition advancing (if it is established)

Removal

 PERFORMANCE ORDER

    At the disconnected ignition, remove ECM (or PCM). Remove the resistor of an advancing of ignition (2).
1 — the noise suppressor
2 — the ignition advancing resistor

Survey

Measure ignition advancing resistor resistance, using an ohmmeter.

Depending on number on the resistor of an advancing of ignition, value of the resistor change as follows (see the tab. below).


1

0

6

980 — 1020

2

80 — 84

7

1.47 — 1.53

3

157 — 163

8

2.16 — 2.24

4

265 — 274

9

3.53 — 3.67

5

421 — 439

10

6.08 — 6.32

N

666 — 694 i

11

11.8 — 12.2

If result of check not satisfactory, replace the ignition advancing resistor.

Installation

For installation perform the procedure of removal upside-down.