Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 release

Repair and operation of the car



Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
- Wheels and tires
   - General description
      Tires
      Wheels
      Tires for replacement
      Replacement of a wheel
      The cap-type nuts and wheel hairpins
   + Diagnostics
   + Servicing and small adjustment
   + Service out of a workshop
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment


9df16362

Replacement of a wheel

Wheels are subject to replacement if they are bent, on them there are dents, they have an excessive side or radial beating, leak of air through welded connections, the extended bolted openings if nuts stand not densely if they strongly rusted. Wheels with a big beating, than it is shown in the drawing, can cause undesirable fluctuations.

The wheels established when replacing have to be similar initially established on the loading capacity, diameter, rim width, shift and a fixing configuration. The wheel of the improper size or type can affect service life of a wheel and the bearing, cooling of brakes, calibration of the speedometer \odometer, a road gleam with a body and the chassis.

For measurement of a beating of a wheel it is necessary to use the exact indicator. The tire can be on a wheel or is removed from a wheel. For the correct measurement the wheel should be installed on the stand for balancing.

The side and radial beating from an internal and external zakraina of a rim is measured. The indicator is strongly installed on a wheel, the wheel is slowly rotated on a whole revolution and write down all indications of the indicator.

If the measured beating exceeds the specified value, and at the stand it is not possible to adjust a deviation, the wheel should be replaced. If instrument readings are distorted due to welding, paint or scratches, they can be neglected.

Limit of a side beating of "a": 1.20 mm (0.047 inches)
Limit of a radial beating of "b": 1.20 mm (0.047 inches)