Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
- 9. Transmission
   + 9.1.2. Technical characteristics
   + 9.2. A Mehnichesky transmission
   - 9.3. An automatic transmission
      9.3.2. Technical characteristics
      9.3.3. Removal and installation automatic gearbox
      9.3.4. Partition automatic gearbox
      9.3.5. A rope of the lever of a gear change
      9.3.6. Evident repair of a transmission 097
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


9df16362

9.3.3. Removal and installation automatic gearbox

Removal

PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Remove the bottom panels of the engine.
3. Disconnect a wire of the minus plug of the accumulator.

TRANSMISSION 01N

PERFORMANCE ORDER
1. Disconnect a wire from the oxygen gauge.
2. Fix the engine on the lift.
3. Remove forward wheels.
4. Remove a cross-beam from under a transmission.
5. Remove forward section of an exhaust pipe.
6. Disconnect wires in a back part of a transmission.
7. Disconnect a wire from the speedometer gauge.
8. Disconnect shaft from leading flanges.
9. Remove a starter.
10. Braid the nuts connecting a leading disk and the hydrotransformer.
11. Establish a jack under a transmission.
12. Disconnect a rope of the lever of a gear change from an arm.
13. Disconnect a rope of the lever of a gear change from the switching lever of a transmission.
14. Remove the right support of a transmission together with an arm.
15. Remove the left support of a transmission.
16. Turn off connections of tubes трансмиссионной liquids and merge a liquid.

17. On the transmission unscrew a bolt (2), remove sealing rings (1) and disconnect two tubes трансмиссионной liquids (And and).
18. In 5-cylinder engines unscrew bolts, fastening a jet bar.
19. Slightly lower a transmission.
20. Unscrew bolts, fastening a transmission to the engine.
21. Disconnect a transmission from the engine.

TRANSMISSION 097

PERFORMANCE ORDER
1. Disconnect a wire from the speedometer gauge.
2. Unscrew a bolt, крепящий a jellied tube to the engine, and disconnect a tube.
3. Unscrew the top bolts, fastening a transmission to the engine.
4. Fix the engine on the lift.
5. Remove a cross-beam located under catalytic the converter and / or under final system.
6. Remove forward section of an exhaust pipe.
7. Disconnect shaft from leading flanges.
8. Remove a starter.
9. Braid the nuts connecting a leading disk and the hydrotransformer.
10. Remove теплоизоляционный a guard from the multipurpose switch.
11. Disconnect wires in a back part of a transmission.
12. Disconnect tubes трансмиссионной liquids from a transmission and merge a liquid.
13. Establish a jack under a transmission.
14. Unscrew fixing bolts of a transmission and slightly lower it.
15. Disconnect the right support of a transmission and disconnect from a support a rope of the lever of a gear change.
16. Unscrew the remained bolts, fastening a transmission to the engine.
17. Disconnect a transmission from the engine and lower it.

Installation

Installation is spent upside-down removals.