Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
- 3.3. Removal and a partition of engines
   + 3.3.2. Technical characteristics
   3.3.3. Repair work, possible without engine dismantle
   + 3.3.4. Major repairs
   3.3.5. Removal and engine installation
   3.3.6. An engine partition
   + 3.3.7. A head of cylinders
   3.3.8. Pistons and rods
   + 3.3.9. A cranked shaft
   3.3.10. An intermediate shaft
   3.3.11. The block of cylinders
   3.3.12. Radical bearings and bearings of rods
   3.3.13. Piston rings
   3.3.14. The first start of the engine after a partition
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice


9df16362

3.3.3. Repair work, possible without engine dismantle
THE GENERAL DATA

Without dismantle of the engine from the car it is possible to execute set of the basic operations on repair.

Before the beginning of any works it is rather desirable to wash out a motor compartment and the engine a water stream. To work with the pure engine it is easier, pollution of the internal device of the engine is prevented.

To expand working space and not to damage colouring, uncover a motor compartment and hinged mudguards.

If traces of leaks of oil or the cooling liquid, specifying in necessity of replacement of linings all works as a rule are spent without engine dismantle are observed. Without dismantle it is possible to replace a lining of the oil pallet, a head of the block of cylinders, linings of inlet and final collectors, forward and back covers, an epiploon of a cranked shaft.

Without engine dismantle also it is possible to remove such hinged units as the pump of a cooling liquid, a starter, the generator, the distributor of ignition, inlet and final collectors, and also the fuel pump and the carburettor.

As the head of the block of cylinders too can be removed without engine dismantle repair клапанного the mechanism is possible also.

Without dismantle it is possible to perform also such works as replacement or check of a condition of a gear belt, gear wheels of a drive of a cam-shaft, the oil pump, consolidation of a forward cover.

In extreme cases when there is no necessary equipment, without engine removal it is possible to replace piston rings, pistons, rods and шатунные loose leaves, отхоннинговать cylinders. However, to perform these works without engine removal it is not recommended, as clearing of accompanying details and preparatory measures are required.