| 1. Remove a protective casing of a fuel tank and disconnect ropes of a manual brake. |
|
2. Disconnect brake tubes and remove ropes, wires and brake tubes from fastenings on a cross-beam.
|
| 3. Check up, that all elements have been disconnected and did not disturb to cross-beam removal. |
|
4. Turn off fixing nuts and bolts, fastening suspension bracket racks to a cross-beam. |
| 5. Turn off fixing bolts of a support and remove a support from a rack. |
| 6. Turn off a fixing nut and remove a bolt, крепящий cross-section draught in a suspension bracket cross-beam. |
|
7. Turn off and remove шарнирные bolts and remove a cross-beam. |
|
8. Examine plugs of fastenings and replace them if it is necessary. At installation of plugs check up, that the central line In between cuts was at an angle 904 to an axis of longitudinal draught And. |
