Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
- Windows, mirrors, locks and security measures. Immobilizer
- Windows, mirrors, locks and security measures
+ General description
+ Diagnostics
- Maintenance
+ Cleaner and washer of a windshield
Screen wiper electric motor
Windscreen washer pump
Control system of electrowindow regulators
System of blocking of locks (if the system allowing to get to interior of the car without key is not installed)
+ System of blocking of doors with a radiobrelka (if the system allowing to get to interior of the car without key is installed)
System of the electric drive of mirrors
Heater of side mirrors (if it is equipped)
Heater of a front seat (if it is equipped)
+ Immobilizer
+ Electric equipment
|
Windscreen washer pump
|
|
|
|
Connect conclusions of the "+" and "-" battery to the corresponding plugs of the pump to check pump productivity.
|
Pump productivity: it is more, than 1 l/min.
|
|
1 — a windscreen washer tank |
Disconnect "weight" from the rechargeable battery.
Disconnect the socket from the combined switch.
Put the cleaner switch in position of "INT".
Expose adjustment of intensity in the provision of "FAST".
|
|
Connect a positive conclusion of the battery to the B3 plug and a negative conclusion to the plug "E".
|
Connect a positive conclusion of the voltmeter to the +1 plug and a negative conclusion to the plug "E".
Check that the voltmeter showed the battery charge level (10 – 14 V).
|
|
a — low intensity
b — high intensity
Е — a negative conclusion to the plug |
|
|
Connect among themselves the As and B3 plugs by means of a connecting wire. Then connect other end of the connecting wire connected to the B3 plug, to the plug "E". Pay attention to power failure to 0. In, right after connection of a connecting wire from the B3 plug to the plug "E". Then tension is restored up to the tension of a charge of joint stock bank (10 – 14 V) during the time specified in the table below.
|
|
|
Connected operations of windscreen washer
|
|
Disconnect "weight" from the rechargeable battery.
|
|
Disconnect the socket from the combined switch.
|
Make sure that the switch of operating modes of forward janitors is in situation "is switched off".
|
|
Connect a positive conclusion of the battery to the B3 plug and a negative conclusion to the plug "E".
|
Connect a positive conclusion of the voltmeter to the +1 plug and a negative conclusion to the plug "E".
Pull the switch of operating modes of a cleaner and check that tension changes.
|
|
and — windscreen washer is included |
|
|
|
|
