Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 release

Repair and operation of the car



Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
- Suspension bracket
   - Forward suspension bracket
      General description
      + Diagnostics
      - Service out of a workshop
         Stabilizer of cross stability / plug
         Shock-absorber rack
         Cylindrical spring
         Limiter of the dynamic course of a suspension bracket / Rubber nest of a spring
         Wheel nave (including the wheel bearing)
         Rotation hinge/axis
         Suspension bracket/plug lever
   + Back suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment


9df16362

Shock-absorber rack

Removal

 PERFORMANCE ORDER

    Remove a bar of a rack (1) (if is available).
    Lift the car that the forward suspension bracket freely hung. Remove a wheel.
    Remove the E-shaped ring (1) protecting a brake hose and remove a brake hose from a rack bracket, as shown.
    If there is a system of anti-blocking of brakes (ABS), remove a bolt (1) of the plug of a wire of the sensor of speed of a forward wheel.
    Remove bolts of a bracket of a rack (1), then a jack (3) the lower lever (2).
    Remove nuts of a support of a rack (1). Hold a rack with a hand that it did not fall.
    Remove a rack.
    Remove a nut of a rack (1), the top nest (2), a support (3), a boot (4) and the lower nest (5) from a rack of the shock-absorber (6).

Installation

 PERFORMANCE ORDER

    Establish a rack, carrying out in the return sequence steps on its removal 1 – 9. Put bolts in the specified direction.
1 — a shock-absorber rack
2 — the lower nest
3 — a boot
4 — a rack support
5 — the top nest
6 — a rack nut
    Tighten all fasteners to the specified values of the moment of an inhaling.
      Inhaling moment:
        nut of a rack (a): 90 N • m (9.0 kg-m, 65.0 pounds feet) nut of a support of a rack (b): 55 N • m (5.5 kg - m, 40.0 pounds feet) bolt of a bracket (c): 95 N • m (9.5 kg-m, 69.0 pounds feet) bolt (d): 50 N • m (5.0 kg-m, 36.5 pounds feet)

  • Installation of a brake hose.
  • At installation of a hose do not overwind it. Establish an E-shaped ring (1), without going beyond a surface of a bracket (2).