Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 release

Repair and operation of the car



Suzuki Grand Vitara
+ General information
+ Maintenance and lubricant
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft / bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ System of ignition
+ System of start
+ System of release
+ Transmissions
- Coupling
   General description
   Diagnostics
   - Service out of a workshop
      Liquid check
      Coupling pedal height
      Free wheeling of a pedal of coupling
      Tube and hose of liquid for coupling
      Main cylinder of coupling
      Coupling work cylinder
   + Repair of the module
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment


9df16362

Tube and hose of liquid for coupling

1 — the main cylinder of coupling
2 — a coupling tube

3 — a coupling hose
4 — the working cylinder of coupling

Removal

Avoid hit of liquid on the painted surface.


 PERFORMANCE ORDER

    Remove dust and dirt from each hose connection (2) and a tube (1) which will be separated, and clear around a tank cover.
    Gather liquid the syringe or something similar. Disconnect a tube for liquid from a hose.

To disconnect a tube (1) from a hose (2), separate them by means of a key for razvaltsovanny nuts (4) and a wrench (3) so that not to overwind them.

Check

Check a tube (1) and a hose (2) for dents, excesses, cracks, dirt and dust. If results of check are unsatisfactory, replace.

Installation

Perform the procedure of removal in the return sequence, paying attention to the following:

Tighten razvaltsovanny nuts (3) to the specified value of the moment of an inhaling. Moment of an inhaling (a): 16 N • m (1.6 kg-m, 11.5 pounds feet).

  • For air drain only from the main cylinder, it needs to be removed from the car.
  • The procedure of removal and installation of the main cylinder and drain of air is described in the Section the Main cylinder of coupling.
  • Avoid hit of liquid on the painted surfaces.
  • You watch that the tube (1) and a hose (2) did not concern the car or other parts.
  • Reliably establish all clips.
  • Reliably establish an E-shaped ring (3).
  • After installation check a free wheeling of a pedal of coupling and pit air from system.
  • Check whether there is no liquid leak.
  • Add liquid approximately to the mark MAX (maximum) in the tank.